MVP-C

Description

The MVP-C is a proportional valve controller housed in an 18mm DIN connector body.  The controller provides current to a valve solenoid in response to an input signal provided by the control system.  LED indicators on the module provide an overview of the operating status.  System configuration is accomplished through a clip-on infrared adapter, without removing or opening the connector body.  All settings are stored in permanent memory within the unit.  The unit is prewired and permanently sealed.

Features

• Easily configured using WhiteOak Terminal software or our hand held interface
• LED indication of Status and Output Current
• Standard, permanently sealed DIN 43650 Form A connector body
• Selectable dither frequency up to 300 Hz
• Adjustable current limited output with short circuit protection
• 5 volt reference for potentiometer/joystick controls
• Programmable enable input
• All input and output limits are independently adjustable
• Adjustable ramp up and ramp down times
• Pre-wired 18 AWG PVC cable
• Microprocessor controlled for consistent, reliable performance

Operating Specifications

User's Manual

For detailed information about the MVP, download the User's Manual: 
D-MVPC-E.PDF

Part Numbers

The following part numbers are available in the MVP series:

• MVP-C1V-06A-10F - 0-10V input, 600mA max output, 10ft cord
• MVP-C2A-06A-10F - 0-20mA input, 600mA max output, 10ft cord
• MVP-C1V-12A-10F - 0-10V input, 1.2A max output, 10ft cord
• MVP-C2A-12A-10F - 0-20mA input, 1.2A max output, 10ft cord
• MVP-C1V-25A-10F - 0-10V input, 2.5A max output, 10ft cord
• MVP-C2A-25A-10F - 0-20mA input, 2.5A max output, 10ft cord

For custom cord lengths replace -10F with -xxF where xx = length in feet.

Ordering Information

To order products,

Email:  orders@whiteoakcontrols.com

Fax:  877-469-9815